Quick Start Install; Connect All Of The Following Wires; Plug-In The Module; Auto Tach Learn - Ultra Start 1350 Installation Manual

QUICK START INSTALL

Step 1 - Connect All Of the Following Wires
6 Pin Power Connector
Yellow Starter Output
Green Heater Output
Red 12 power Input
Red 12 power Input
Blue Ignition 1 Output
White Selectable Output
11 Pin Power Connector
Black
White
Green/White
4 Pin Power Connector
Blue/White
Pink
Manual Transmissions Only
Purple
Green
Black/White
Note: Manual Transmission units MUST be set into Reservation Mode to remote start.
See page 10. for details.
Step 2- Plug-In The Module
When all the connections are done, the control module can be plugged in. Before connecting the control
module, make sure the ignition is in the OFF position. Plug in the 6 pin harness then the 14 pin followed
by any other connectors that were used.
Step 3- Auto Tach Learn
1) Make all the required wire connections and plug-in the Unit.
**The park lights should flash twice upon power up.
2) Turn the Ignition Key ON. (Park Lights will turn on).
3) Start the vehicle, LED's on antenna will come when proper tach signal is detected**, then after 30-35
seconds the park lights will turn off then flash twice to confirm tach learning.
* The system will flash the park lights seven times if not tach learned and the start button is
pressed. The system must be tach learned before remote starting.
** If the LED's do not come on during tach learn, a proper tach signal was not detected
Note: If the park lights do not flash in auto tach learn mode it may be necessary to connect to a different
tach source. For best results connect the tach wire to the coil pack or to a fuel injector wire. See Page 8
for tach adjustment.
***New - A system reset must be done before a new tach signal can be learned to the system.
Your Basic Install Is Complete!
NOTES:
1) If the unit does not start, check the starter is not in Tach Lock Out or in Program Mode.
Your Basic Installation is Now Complete!!
2) If the vehicle still does not start, check all connections and check for factory security.
6
Connect To The V ehicles Starter Wire.
Connect To The Vehicles Accessory Wire.
Connect To Constant 12 Volt Power Source- High Current.
Connect To Constant 12 Volt Power Source- High Current.
Connect To the Vehicles Primary Ignition.
Select Jumper Position (If Necessary). See Page 5.
System Ground Connect To Chassis Ground.
Park Lights Connect To (+) Park Light System.
Hood Pin Connect To The Hood Pin Safety Switch.
Tach Connect To A/C Tach Source. (Above 2volts AC)
Brake Switch Connect To (+) When Brakes Is Applied.
(+) Door Pin Connect on vehicles with (+) door pin systems
(-) Door Pin Connect on vehicles with (-) door pin systems
Park Brake Connect to park brake switch. (-) When brake is applied.
Installation Guide