Table of Contents
Advertisement
REMOTE VEHICLE STARTER
6 Pin Power Connector
6-pin
Description
1-Yellow
30amp Starter Output
2-Green
30amp Heat/Acc Output This wire will test 0volts in the off position 12-
3-Red
30amp Power Input
4-Red
30amp Power Input
5-Blue
30amp Ignition Output
6-White
30amp Select Output
14 pin connector
14 Pin
Function
1-Yellow
Re-Arm
2-Orange
St.kill and Anti-Grind
3-Brown
Disarm
4-Red/Wht Trunk Release
5-Wht/Violet GWR
6- Green
(-) Door Pin
7-Green/
Hood Pin
White
8-Purple
(+) Door Pin
9-Pink
Brake input
10-Black
Ground
Continued on next page.
INSTALLATION MANUAL
Test For Wire
This wire will test 0volts in off, accessory and in
the ignition position.12volts during start only.
14volts in the accessory and run positions and
0 volts during start
12volts at ignition harness or from battery.
Supplies power for the ignition, selectable
output and park light relays.
12volt power at ignition harness or from battery.
Supplies power for accessory and start relays
This wire will test 0volts in the off and accessory
position 12volts in the ignition, start and run.
Selectable output for 2nd Ign, acc or starter.
Description
0.75 second Pulsed output when locked and on
remote start shutdown. Used for factory alarm re-
arm. Programmable output. See Menu 3
Negative output when locked and during remote
start. Used for optional starter disable, and anti-
grind relay. Programmable output. See Menu 3
0.75sec pulsed output when Unlocked and pulse
before remote start activation. Used for Factory
Alarm Disarm.
Hold the unlock button for 3 seconds. Output will
stay on until the unlock button is released (Max 5
seconds Programmable to (-)Park lights.
(-) Output while remote starter is activated. Used to
activate Anti-thef bypass modules.
Input to detect door opening. Connect to door pin
that switches to (-) when the door is opened.
Negative input from hood pin safety switch. Switch
is grounded when the hood is opened.
Input to detect door opening. Connect to door pin
that switches to 12volts when the door opened.
Positive Brake Input. Used to detect the brake
switch being applied. Found at the brake switch
connector.
System Chassis Ground Input.
Page 7
Advertisement
Table of Contents
