Ultra Start 45 SERIES Install Manual page 20

INSTALLATION MANUAL
Page 20
Setting 6 Anti-Grind/Starter Kill (Orange wire on 14-pin)
1) Active 1 Flash/chirp
2) Passive 2 Flashes/chirps
*3) Anti-grind 3 Flashes/chirps
Press & Release the Program Button 6 Times (Setting 6) Confirmed with 6 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 7 Safety Start
1) Safety On 1 Flash/chirp
*2) Safety Off 2 Flashes/chirps
Press & Release the Program Button 7 Times (Setting 7) Confirmed with 7 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 8 Positive Disconnect/ Instant Start (Blue wire on 3-pin side connector)
1) Instant Start
*2) (+) Disconnect 2 Flashes/chirps
Press & Release the Program Button 8 Times (Setting 8) Confirmed with 8 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Menu 4- Tach Settings
Setting 1 Auto Tach Learn.
1) Perform a System Reset. See page 15.
2) Turn the ignition key on. (Park lights will turn on).
3) Start the vehicle, the LEDs on the antenna will come on when a proper tach signal is detected*.
4) After approximately 30-35 seconds the park lights will go out then will flash twice and the siren
will chirp twice to confirm that a tach signal has been learned.
Setting 2 Over-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button twice. (LEDs will flash 2 times consecutively)
4) Press and hold the Program Button. The park lights flash and the siren will chirp one time.
*Each time the park lights flash and the siren chirps the setting is reduced.
5) Release the Program Button. (Exit Program Mode and test remote starter)
Setting 3 Under-Crank Adjustment.**
1) Enter Program Mode (turn ignition ON-OFF-ON-OFF-ON), press and release the Program Button.
2) Press and release the # button on the remote.
3) Press and release the Program Button three times. (LEDs will flash 3 times consecutively)
4) Press and hold the Program Button. The park lights will flash and the siren will chirp one time.
*each time the park lights flash and the siren chirps the setting is increased.
5) Release the Program Button. (Exit Program Mode and test remote starter)
(-) when locked and during remote start (Anti-Grind).
(-) when locked /30 seconds after ignition is Off or unlock is pressed
Output during remote start only. (Anti-grind/ Bypass module)
Press the start button twice within 3seconds to remote start vehicle.
Press the start button once to remote start vehicle.
1 Flash/chirp 12volt trigger will activate remote starter
Removing 12volts from this wire will trigger alarm.
REMOTE VEHICLE STARTER