Table of Contents
Advertisement
REMOTE VEHICLE STARTER
Menu 3- Starter Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Button #3
Setting 1 Special Door Lock/Unlock Operations (Factory Alarm Rearm).
1) Type 1
2) Type 2
*3) Type 3
Press & Release the Program Button 1 Time (Setting 1) Confirmed with 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 2 14pin Connector- Gas/Diesel Mode (Blue wire on 14-pin)
1) (-) Input
2) Time Delay
*3) Gas/ (+) Input
Press & Release the Program Button 2 Times (Setting 2) Confirmed with 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 3 Rearm Output (Yellow wire on 14-pin)
1) Type 1
2) Type 2
*3) Factory Re-arm 3 Flashes/chirps
Press & Release the Program Button 3 Times (Setting 3) Confirmed with 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 4 Run Time
1) 4 Minutes
2) 45 Minutes
*3) 15 Minutes
Press & Release the Program Button 4 Times (Setting 4) Confirmed with 4 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 5 Maximum Crank Time
1) 10 Seconds
2) 3 Seconds
*3) 5 Seconds
Press & Release the Program Button 5 Times (Setting 5) Confirmed with 5 LED flashes.
Press & Hold the Program Button until the appropriate # of park lights/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
INSTALLATION MANUAL
Unlock before start. Lock pulse after start and on shutdown.
Lock pulse ONLY after remote start shutdown.
Default Lock/ Unlock Pulses.
(-) Glow Plug input. Waits maximum 30 seconds then starts.
Waits for approximately 15 seconds then remote starts.
Waits 2 seconds to start if no diesel input is detected.
Pulse after start and with lock. (Provides Lock Pulse)
Pulse after start only. (Provides Lock Pulse)
Pulse with lock and after starter shutdown.
Runs for approximately 4 minutes when activated.
Runs for approximately 45 minutes when activated.
Runs for approximately 15 minutes when activated.
10 sec max time that the starter will stay engaged.
3 sec max time that the starter will stay engaged.
5 sec max time that the starter will stay engaged.
Page 19
Advertisement
Table of Contents
