Table of Contents
Advertisement
INSTALLATION MANUAL
Page 18
Menu 2 - Additional Settings
Ignition ON-OFF-ON-OFF-ON
Press & Release Program Button
Press Button #2
Setting 1 Secure Valet Mode - Length of time required to set the system into Service Mode
1) Secure Valet
*2) Normal Valet
Press & Release the Program Button 1 Time (Setting 1) confirmed 1 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirenchirps, then release.
Press & Release the Program Button to proceed to the next step
Setting 2 Parking Light/Trunk Output (White and Red/White on 14-pin)
1) 30 sec. Output
2) Negative Park Lights
*3) Park Lights
Press & Release the Program Button 2 Times (Setting 2) confirmed 2 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 3 Horn chirp Timing (White/Blue on 4-pin)
1) 5 ms Pulse Output
2) 15 ms Pulse Output
*3) 10 ms Pulse Output 3 Flashes/chirps
Press & Release the Program Button 3 Times (Setting 3) confirmed 3 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/siren chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 4 Not Available
Setting 5 Siren/Horn (Automatic transmission only)
1) Horn Output (+)
*2) Siren output
Press & Release the Program Button 5 Time (Setting 5) confirmed 5 LED flashes.
Press & Hold the Program Button until the appropriate # of park light/sirne chirps, then release.
Press & Release the Program Button to proceed to the next step.
Setting 5 Reservation Mode ("M" units only)
1) Manual Reservation
*2) Auto Reservation
Note: Menu 5 is specific to model number. Auto transmission modules with have the siren/horn
programmable and manual transmission will have the choice of auto or manual Reservation Mode.
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
3 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
1 Flash/chirp
2 Flashes/chirps
REMOTE VEHICLE STARTER
Hold the Program Button for 15 seconds
Hold the Program Button for 5 seconds
Park Lights on for 30 seconds when Unlock is pressed
Switches the Park Lights/Trunk Outputs
2 Park Light Flashes when Unlock is pressed
Short(Quiet) Horn Output Pulses
Long(Loud) Horn Output Pulses
Normal(Medium) Horn Output Pulses
Pulsed output for horn activation
Constant output for siren activation
Activate Reservation Mode by pressing Button #4
Activate Reservation Mode by pressing brake
*(Default Settings)
Advertisement
Table of Contents
