System Reset - Ultra Start 450 SERIES Install Manual

Advanced vehicle security system

Hide thumbs Also See for 450 SERIES:

Table of Contents

PAGE 9

SYSTEM RESET

SYSTEM PROGRAMMING - Menu 1

This connector is used when installing the optional keyless entry feature. If the door lock type of

the vehicle is not negative see the following pages for the appropriate door lock diagram.

Pin 1- Green Wire- Negative Lock Output

Connect to lock wire from the switch on vehicles with a negative type switch.

**LOW CURRENT ONLY**

Pin 2- 12volt Output for Door Lock Module

This output will supply 12volts for a plug-in type door lock module. Do not use this input to power-

up relays **LOW CURRENT ONLY**

Pin 3- Blue Wire- Negative Unlock Output

Connect to lock wire from the switch on vehicles with a negative type switch.

**LOW CURRENT ONLY**

SYSTEM RESET

1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)

2 - Press and RELEASE the Program Switch 1 time.

(HORN will chip to confirm program mode entered)

3 - Press and HOLD the Program Switch for until the HORN Chirps 3 times.

4 - Turn ignition key OFF to exit.

ENTERING REMOTE PROGRAM MODE

1 -

2 -

3 -

3 PIN KEYLESS CONNECTOR

Cycle the Ignition Key - ON/OFF ON/OFF ON

(Leaving the key ON)

Press and release the program switch (The siren will chirp)

**If the siren does not chirp repeat step 1-2.

Hold the program switch until the siren chirps 3 times.

1 chirp confirms program mode entered followed by

3 chirps confirming that the system has reset.

450 SERIES

INSTALL MANUAL

Table of Contents