Table of Contents
Advertisement
450 SERIES
INSTALL MANUAL
This feature will disable or re-enable the alarm without the use of the remote transmitter. This
feature will work when alarm in either an armed, disarmed or triggered state. When the system's
override had been activated, door lock and trunk features will still be operational however the
alarm will be active.
Turn the Ignition Key ON
(Leaving the key ON)
5 CHIRPS = ON
2 CHIRPS = OFF
The LED status light will come on "STEADY" to confirm Valet Mode is ACTIVE
The LED status light will be "OFF" to confirm Valet Mode is NOT ACTIVE and system
is in normal alarm operation mode.
ADDITIONAL LED FUNCTIONS
While the system is disarmed and the ignition is in the off position, the
LEDs will activate from the following triggers.
1) If the door is opened the LEDs will stay on until the door is closed.
2) If the hood is opened the LEDs will stay on until the hood is closed.
3) If the shock sensor detects vibration the LEDs will turn on momentarily.
4) If the auxiliary sensor input is activated the LEDs will activate momentary.
VALET MODE / EMERGENCY OVERRIDE
Siren will chip 5 times to confirm Valet Mode / Emergency Override
has been activate or 2 times for deactivate (If alarm was in a triggered
state, the siren will shut off and park lights will stop flashing)
SYSTEM PROGRAMMING - Menu 1
VALET MODE
Press and hold the valet switch for 8 to 15
seconds (Time depends on "Valet
Settings" Program Option)
PAGE 14
Advertisement
Table of Contents
