450 SERIES
INSTALL MANUAL
NEGATIVE OUTPUT FOR LOCK
12+ OUTPUT FOR DOOR LOCK MODULE
NEGATIVE OUTPUT FOR UNLOCK
FOR MORE DETAILED INFORMATION ON PROGRAMMING, WIRING DIAGRAMS, DOOR LOCK
ENTERING PROGRAM MODE
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time.
HORN will chip to confirm program mode entered
3 - Select the Program Menu by pressing...
Press Lock
The Siren will chirp to confirm that the system is in MENU 1
Continue to step 4.
Press Unlock
The Siren will chirp to confirm that the system is in MENU 2
Continue to step 4.
4 - Press and Release the Switch to advance through the settings.
(Confirmed by HORN chirps & LED flashes)
5 - Press and hold the Program Switch to change the setting.
(Confirmed by HORN Chirps)
6 - To exit Program Mode, turn key off.
(Confirmed by Long HORN Chirp)
3 PIN KEYLESS CONNECTOR
CONFIGURATION AND OTHER INFORMATION, PLEASE VISIT
WWW.ULTRASTARTERS.COM/DIAGRAMS
SYSTEM PROGRAMMING - Menu 1
SYSTEM WIRING
GREEN
RED
BLUE
PAGE 8