Entering Program Mode; Quick View Programming; System Reset - Ultra Start 430 Series Install Manual

PROGRAM OVERVIEW
Program mode allows you to adjust the settings and options of your system. Your system
has been intelligently designed by installers with years of experience. The system's default
settings do not require any program changes in most cases. However, this system does
incorporate a advanced programming system with settings that can be easily adjusted

Entering Program Mode

To Enter Program Mode
1) Make sure ignition is in the off position.
2) Within three seconds turn the key ON the OFF.
3) Press and release the Program Button two times.
4) The siren will chirp and the lights will flash once to confirm entering Program Mode.
Note: If unit does not enter Program Mode, turn ignition off and repeat steps 1-3.
** The ignition wire(Yellow) MUST be connected. If it is not connected it will not be possible
to enter the Program Modes.
Changing A Programmable Setting
1) Enter Program Mode As explained above.
2) When in program Mode, change the desired Program Setting by pressing the
transmitter buttons in the following sequences.
***The Systems Default Setting Are Shown In Bold Lettering.

Quick View Programming

Programmable Feature
Shock Sensor Status
Arm / Disarm Chirps
Ignition Auto Locks
Door Lock Pulse Length
Double Pulse Unlock
Door Input / Voltage Sense
Passive / Active Locks
Passive / Active Arming

System Reset

System Reset
This feature will reset the module to it's factory programmed default setting. This feature
will not delete transmitter codes from memory.
To Reset The System To Factory Defaults.
1) Turn the ignition key On then Off.
2) Press the Program Button two times. The system will respond with two siren chirps.
3) Press the transmitter buttons in the following order: #3-#3-#3. The system will respond
with three siren chirps to confirm the system has been re-set to factory defaults.
Press Buttons
#3-#3-#1
#2-#1-#1
#1-#3-#2
#1-#3-#1
#2-#2-#1
#1-#1-#3
#3-#2-#2
#1-#2-#3
#3-#3-#3 Confirmed by Three Siren Chirps
One Chirp Two Chirps
Disabled Enabled
Chirps Off Chirps On
Off On
3 Second .75 Second
Two Pulses Single Pulses
Voltage Door Pin
Active Passive
Active Passive