Ultra Start 450 SERIES Install Manual page 12

450 SERIES
INSTALL MANUAL
Cycle the Ignition Key
ON/OFF ON/OFF ON
(Leaving the key ON)
STEP 2 - SELECT / CHANGE PROGRAM SETTINGS
SETTING 1 - VALET SETTINGS
THE SIREN WILL CHIRP 1 TIME WHEN SETTING 1 IS SELECTED
CHANGE SETTING 1 -
GOTO SETTING 2 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP
DEFAULT SETTING
2 CHIRP
SETTING 2 - PARKING LIGHT OUTPUT
THE SIREN WILL CHIRP 2 TIMES WHEN SETTING 2 IS SELECTED
CHANGE SETTING 2 - PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
GOTO SETTING 3 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP
2 CHIRP
DEFAULT SETTING
3 CHIRP
SETTING 3 - AUX CHANNEL OUTPUT
THE SIREN WILL CHIRP 3 TIMES WHEN SETTING 3 IS SELECTED
CHANGE SETTING 2 - PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
GOTO BACK TO SETTING 1 - PRESS & RELEASE THE VALET SWITCH
1 CHIRP
2 CHIRP
DEFAULT SETTING
3 CHIRP
STEP 1 - ENTER PROGRAM MODE - MENU 2
Press and release the
Program Switch 1 time.
PRESS & HOLD THE VALET SWITCH UNTIL THE SIREN CHIRP(S)
SETS OPTION 1 – SECURE VALET - The LED/ Program Switch must
be held for 15 seconds to place the system into Valet Mode.
SETS OPTION 2 – STANDARD VALET-
held for 5 seconds to place the system into Valet Mode.
SETS OPTION 1 – 30 SECOND- The park light output will flash for all
functions and will stay active for 30 seconds when unlock is pressed.
SETS OPTION 2 – Trunk Release- The park light output will act as a
positive trunk output. The trunk output acts as a negative park light.
SETS OPTION 3 – Normal Operation- The park lights will flash for all
alarm functions.
SETS OPTION 1 – Pulsed Output- The channel 3 output will pulse for .75 seconds
when activated.
SETS OPTION 2 – Latched Output- The channel 3 output will latch on when activated.
Turning the ignition on will cancel the latch.
SETS OPTION 3 – Active Output- The channel 3 output will stay on as long as the
button is held for a maximum of 5 seconds.
SYSTEM PROGRAMMING - Menu 1
PROGRAMMING
1 CHIRP
Siren will chip to confirm
program mode entered
PRESS
1 CHIRP
1 TIME
The LED/ Program Switch must be
PRESS
2 CHIRP
2 TIMES
PRESS
3 CHIRP
3 TIMES
PAGE 12
Press Unlock Button on
Remote to Select Menu 2
X1
X2
X3