Table of Contents
Advertisement
PAGE 5
TRANSMITTER PROGRAMMING
SYSTEM PROGRAMMING - Menu 1
TRANSMITTER PROGRAMMING
The system can lean up to 4 different remote's. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote is
programmed all previous remote's are deleted. Please see remote operation chart for
information on using Second Car / Pad Lock Operations
ENTERING REMOTE PROGRAM MODE
1 -
2 -
3 -
PROGRAMMING REMOTE'S
Press & Release LOCK button on 1st Remote to be
4 -
Programmed for Normal Operation If remote(s) are to be
programmed for "PADLOCK" skip and goto step 6
Siren will Chirp 1 time to confirm remote has been programmed
5 -
(If siren does not chirp press button again)
REPEAT STEP 4 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR NORMAL OPERATION
Press & Release BUTTON 4 on Remote to be Programmed for
6 -
2ND CAR OR PAD LOCK
Siren will Chirp 1 time to confirm remote has been programmed
7 -
(If siren does not chirp press button again)
REPEAT STEP 6 IF A SECOND REMOTE IS TO BE PROGRAMMED FOR 2ND CAR / PADLOCK OPERATION
8 -
NOTE: ALL REMOTE'S TO BE USED MUST BE PROGRAMMED IN SEQUENCE
WHILE IN REMOTE PROGRAM MODE, RE-ENTERING REMOTE PROGRAM MODE
WILL ERASE ALL PREVIOUS REMOTE'S
Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)
Press and HOLD the valet switch, siren will chirp ONCE
(If siren does not chirp repeat step 1)
CONTINUE TO HOLD until siren chirps 5 times
1 chirp confirms program mode entered followed by
5 chirps confirming transmitter program mode
Turn ignition key OFF to exit remote program mode when all
required remote's have been programmed.
450 SERIES
INSTALL MANUAL
.
Advertisement
Table of Contents
