Operations; Transmitter Programming; Battery Replacement - Ultra Start 600 Installation Manual

Advanced vehicle security system
Hide thumbs Also See for 600:
Table of Contents

Advertisement

TRANSMITTER OPERATIONS
See Owner's Guide for More Detail on Operations
First Car Operation
First Car
Second Car Operation
2nd Car
then

Transmitter Programming

Step 1 - Within three seconds turn the ignition Key ON-OFF-ON-OFF-ON - Leaving Key ON
Step 2 - Press and hold the Program Switch - Parking Lights will come ON **if park-lights do not come on
at this point, turn key off for 5 seconds, then repeat step 1.
Step 3 - Continue to hold the Program Switch until park lights go out.
Step 4 - Press the LOCK button on each of 1st car remote's and press the # button on each of the 2nd
car remote's of the transmitters to be programmed. The park lights will flash once and the siren
will chirp once each time a new code is learned.
Note: Transmitter programming must done quickly. Do not pause more than one second between each
transmitter. All the transmitters to be used must be programmed at the same time. All transmitters
not programmed at this time will be erased from memory for security. The system holds a
maximum of 3 transmitter codes including 2nd car remote codes.
You can program the same remote as a 1st car remote in one vehicle and as a 2nd car remote in a
second vehicle.

Battery Replacement

The transmitter battery should be changed at least once every year to maintain proper operating range.
Replace with quality23A 12volt Alkaline battery.
Step #1
Carefully remove the
10
screw from back of
the remote.
Press Once to Lock the doors and arm the alarm. Hold for Panic Mode.
Press a second time and hold for Constant Lock Output.
Press once to unlock the doors and disarm the alarm
Press and hold for the Trunk / Aux Output
Press this button to activate the 4th channel output.
This output can be used to activate additional alarm features.
Press once and hold for Car Finder
Press and release then hold to activate/deactivate Service Mode.
&
=
Press Once to Lock the doors and arm the alarm. Hold for Panic Mode.
Press a second time and hold for Constant Lock Output.
&
=
Press once to unlock the doors and disarm the alarm
Press and hold for the Trunk / Aux Output
&
=
Press this button to activate the 4th channel output.
This output can be used to activate additional alarm features.
=
then
Press once and hold for Car Finder
Press and release then hold to activate/deactivate Service Mode.
Step #2
-
Remove top case
then replace the
battery.
Installation Guide
Step #3
Replace top case.
Re-install screw.
Step #4
Test remote for
proper operation.

Advertisement

Table of Contents
loading

Table of Contents