Setting The Clock; Setting The Alarm Times - Grundig Sonoclock 51 SC 5301 User Manual

16
SETTINGS __________________________

Setting the clock

When you switch on the device for the first time, the time flashes in the dis-
play to indicate that you must set the clock. The same applies if the device
has been disconnected from the mains and no back-up battery is inserted.
Press »TIME« and hold down.
1
<
2 Using » « (hold down) set the clock with the time running slowly back-
wards.
and/or
>>
Using » « (hold down) set the clock with the time running quickly
forwards.
Release »TIME« to end the setting.
3
– Display: the set time.
Note:
Using »SNOOZE« (press and hold down), display the seconds (time
e.g. »12:15« and 20 seconds, display: »5:20«).

Setting the alarm times

With this unit, it is possible to set two alarm times, for example, for two peo-
ple.
1 When the alarm is switched off push the sliding switch
2« (on the left of the device) to »1« or »2«.
1+2
– Display: the »ALARM 1
»ALARM 9 e
Using
2
the desired alarm (»e« = signal, »
Press »ALARM«.
3
– Display: the last alarm time set.
»ALARM« press and hold down.
4
<
Using » « (hold down), set the alarm time with the time running slow-
5
ly backwards.
and/or
>>
Using » « (hold down), set the alarm time with the time running
quickly forwards.
Release »ALARM« to end the setting.
6
– The device switches on at the set alarm times with the selected alarm
signal.
• •
« or »ALARM 2
« sliding switch (on the left of the device) set
« = radio station).
»ALARM 1
« LED glows.