GE JGBP26GEN Use And Care & Installation Manual page 45

CONVERTING SURFME BURNERS ON
MODELS EQUIPPED WITH S~LED BURNERS (See
Step 4 if range is equipped with dual burners.)
Burner Head
Orifice Spud
Gas Inlet Tube
Remove grates, burner caps and burner heads.
1.
2. Remove burner bases by unscrewing the 3
small screws in each base. ~
disconnect the wires from the burner
DO NOT
bases unless the cooktop needs to be raised.
3. With 7mm or 5/16" wrench (depending
on the size of your spuds), remove the 4 brass
4. Install orifice spuds accordin to one of the
following diagrams (see
gas or natural gas, depending on which you are
converting to.
—
—.
burner
or for LP
B ),
Orifice Spuds brConve~ingto
with this Use and Care book. LP orifice spuds
have a 2-digit number and the Letter "L" on
one side. Each orifice spud will also have 1 or 2
grooves on one side, denoting the location on
the range where it is to be installed.
Orifice Spuds ferConVefiing to Natural Gas:
Natural gas orifice spuds have a 3-digit number
on one side. Each orifice spud will also have 1, 2
or 3 grooves on one side, denoting the location
on the range where it is to be installed.
Front of Range
(continued next page)
45