GE JGBP26GEN Use And Care & Installation Manual page 44

HOW TO CONVERT THE RANGE FOR USE
WITH 1P GAS OR NATURAL GAS
TOOLS REQUIRED:
T-10 Torxdriver (for sealed burners)
1/2" and 3/4" open-end wrench
Flat blade screwdriver (small)
Nut drivers or wrenches: 7mm or 5/16"
(depending on the size of the spuds)
PREPARE RANGE FOR CONVERSION
(1) Turn off gas supp& at tie wall.
(2) Turn off tie electicd power to tie range.
range has not yet been connected to gas supply,
If
or if flexible connection was made, range maybe
pulled out from the wall to make conversion easier.
CONVERT THE PRESSURE REGULATOR
Do not remove the pressure
1. For models equipped with sealed burners,
remove the storage drawer, broiler drawer or
kick panel and locate the pressure regulator at
rear of the range.
Remove Screws
Access Cover
On some models, you may have to remove an
access cover also.
For models equipped with dual burners, remove
the cooktop and locate the pressure regulator at
right rear of range.
2. Follow the directions in A or B that match
your regulator type.
44
D
is this regulator:
Use a coin to remove the cap from the
1.
pressure regulator.
2. Turn the cap over and hook it into the slots.
The type of gas to be used should now be visible
on the top of the cap.
On some models the shut-off valve
Note:
may be in a different location.
If it is this regulator:
Unscrew the plastic-protected hex-nut cap
1.
from the regulator.
2. Carefully pry the protective plastic cap off
the threaded metal cap. Gently pull the plastic
washer off the threads on the other side of the
metal cap.
3. Push the plastic cap onto the end of the metal
cap displaying the type of gas you are converting
to. Press the attached plastic washer onto the
threads on the other side of the metal cap.
4. Screw the hex-nut cap back into the regulator.
Do not overtighten.
Is the
e in a