GE JGBP26GEN Use And Care & Installation Manual page 41

Seal any openings in the wall behind the range
and in the floor under the range when hookups
are completed.
CHECK SUR~CE BURNER IGNITION
Operation of all cooktop and oven burners
should be checked after range and gas supply
lines have been carefully checked for leaks.
Push in one of the surface burner controls and
turn it to the LITE position. You will hear a
snapping sound indicating proper operation of
the spark module. Once the air has been purged
from the supply lines, burner should light within
4 seconds. After burner lights, rotate knob out of
the LITE position. Try each burner in succession
until all burners have been checked.
The combustion quality of burner flames needs
to be determined visually.
Normal burner flames should look like (B) or
(C), depending on the type of gas you use.
With LP gas, some yellow tipping on outer
cones is normal.
(A) YeUow flames—
Call for service
(B) YeUow tips on
outer cones—
Normal for LP gas
(C) Soft
blue flame-
Normal for natural gas
is designed to operate quietly and
automatically. To operate the oven, press the
until "350°" appears in the display. After 30-90
seconds, the oven burner will ignite and burn
until the set temperature is reached. The oven
burner will continue to cycle on and off as
necessary to maintain the oven at the temperature
indicated by the display.
To check ignition of the broil burner, press the
BROIL pad md then tie INCREASE or DECREASE
pad. After 30-90 seconds, the broil burner will ignite.
The oven requires electrical power to operate. In
the case of a power outige, the oven burners on
these models cannot be lit manually with a match.
Gas will not flow unless the glow bar is hot.
the oven burner shuts off and cannot be relit
until power is restored.
(continued next page)
41