Setting Up As A Print Server - Ricoh Aficio 1075 Operating Instructions Manual

Note
❒ This section assumes NetWare is functional and that the necessary environ-
ment for the NetWare Print Service is available.
❒ When using NetWare 4.x, 5/5.1, you should install the client software re-
leased from Novell in Windows, before running the NIB Setup Tool for con-
figuring in NDS mode or using Windows NT 4.0.
❖ ❖ ❖ ❖ To use NetWare 5/5.1
• Use the printer as a print server. Do not use as a remote printer.
• If you use Pure IP, configure the machine to use the TCP/IP protocol. For
more information about how to make the settings, see the General Settings
Guide.

Setting Up as a Print Server

Important
❒ You can set up the print server using NDS or Bindery mode in NetWare 4.x,
5/5.1. The following procedure is for NetWare 3.x and for setting up the print
server using NDS mode in NetWare 4.1. When you set up the print server us-
ing Bindery mode, use the NIB Setup Tool Wizard. See p.61 "Quick Setup Us-
ing the NIB Setup Tool Wizard".
Note
❒ If you use Pure IP in NetWare 5/5.1, follow the procedure on p.70 "Using
Pure IP in the NetWare 5/5.1 Environment".
A A A A
Log on to the file server as a Supervisor or a Supervisor equivalent.
Note
❒ When using NetWare 4.x, 5/5.1, log on the file server as an administrator
or an administrator equivalent.
B B B B
Run the NIB Setup Tool.
Reference
See p.60 "Running the NIB Setup Tool" .
C C C C
Click [Property Sheet] and click [OK].
The [NIB Setup Tool - Network board list] dialog box of the Network Interface
Board appears.
D D D D
Click [IPX protocol].
NetWare 3.x, 4.x, 5/5.1- Advanced Settings
5
65