Weider 350 Bench User Manual page 8

6. Insert the Backrest Bracket (7) through the indi-
cated hole in the Bench Frame (1).
Apply grease to an M10 x 183mm Bolt (98).
Attach the Backrest Frames (9) to the Bench
Frame (1) with the Bolt, two M10 Washers (83),
and an M10 Nylon Locknut (80). Do not over-
tighten the Nylon Locknut; the Backrest
Frames must pivot easily.
Attach the Adjustment Pin (20) to the Bench
Frame (1) with an M4 x 13mm Self-tapping
Screw (94). Insert the Adjustment Pin into the
Bench Frame and the Backrest Bracket (7).
Tighten the M6 x 40mm Screws (100) used
in step 5.
7. Attach the Seat (12) to the Bench Frame (1)
with four M6 x 16mm Screws (95).
See steps 1–6. Tighten the M10 Nylon
Locknuts (80) used in these steps.
8. Insert a Pad Tube (10) into the Front Leg (3).
Slide two Short Foam Pads (23) onto the Pad
Tube.
Assemble the other two Pad Tubes (10) to the
Leg Lever (4) in the same manner.
9. Attach the Curl Pad (13) to the Curl Post (8)
with two M6 x 16mm Screws (95).
6
9
80
83
83
Grease
1
7
12
8
23
4
10
10
9
13
8
Hole
7
20
98
94
1
95
95
3
10
23
8
95