Weider 350 Bench User Manual page 15

29. Wrap the Butterfly Cable (76) around a "V"-pul-
ley (56). Attach the "V"-pulley and a Large
Cable Trap (63) to the Center Upright (26) with
an M10 x 62mm Bolt (88), two Guards (62), an
M10 Washer (83), and an M10 Nylon Locknut
(80). Make sure the Cable Trap is oriented
to hold the Cable in the groove of the Pulley.
Do not overtighten the Nylon Locknut; the
Pulley must turn freely.
30. Route the Butterfly Cable (76) under a 90mm
Pulley (55). Attach the Pulley to the Double
Pulley Bracket (60) with an M10 x 48mm Bolt
(92), two Half Guards (58), and an M10 Nylon
Locknut (80). Do not overtighten the Nylon
Locknut; the Pulley must turn freely.
31. Route the Butterfly Cable (76) over a "V"-pulley
(56). Attach the "V"-pulley and a Large Cable
Trap (63) to the Center Upright (26) with an
M10 x 62mm Bolt (88), two Guards (62), an
M10 Washer (83), and an M10 Nylon Locknut
(80). Make sure the Cable Trap is oriented to
hold the Cable in the groove of the Pulley.
Do not overtighten the Nylon Locknut; the
Pulley must turn freely.
32. Attach the Butterfly Cable (76) to the Right
Butterfly Arm (34) with an M8 x 22mm Shoulder
Bolt (101) and an M8 Nylon Locknut (81). Make
sure the flat edge of the Cable is against the
Butterfly Arm. Do not overtighten the Nylon
Locknut; the Cable must pivot freely.
29
26
30
76
31
88
62
63
76
83
62
32
15
83 76
80
63
62
62
56
55
58
92
58
60
80
56
80
26
101 76
34
81
88
Flat
Edge