Weider 350 Bench User Manual page 10

13. Insert an M10 x 20mm Bolt (89) into the Weight
Carriage (35). Orient the Weight Carriage and
the Rear Upright (27) as shown. Slide the
Weight Carriage onto the Upright.
Orient the Weight Carriage Stop (48) so the
60mm Bushing (54) is at the top. Slide the
Weight Carriage Stop onto the Rear Upright
(27) and secure it with an M8 x 70mm Bolt (93)
and an M8 Nylon Locknut (81).
14. Attach the Rear Upright (27) to the Rear Base
(25) with two M10 x 68mm Bolts (85), four M10
Washers (83), and two M10 Nylon Locknuts
(80). Do not tighten the Nylon Locknuts yet.
15. Attach a Guide Rod (28) to the right Side Base
(51) with an M8 x 65mm Bolt (79), two M8
Washers (84), two 13mm x 13mm Spacers
(78), and an M8 Nylon Locknut (81). Do not
tighten the Nylon Locknut.
Repeat this step with the left Side Base (51).
13
Tall
Side
27
93
35
48
14
80
83
15
28
78
81
84
51
10
81
89
54
27
83
85
25
78
84
79