PART IDENTIFICATION CHART
Use the drawings below to identify small parts used in assembly. The number in parentheses by each drawing is
the key number of the part, from the PART LIST near the end of this manual. The number following the key num-
ber is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it has been
preattached.
M8 Locknut
(72)–4
M8 x 20mm
Screw (74)–4
M8 Split
Washer (75)–8
M6 x 70mm Bolt Set (50)–1
M6 x 60mm Bolt Set (51)–1
M4 x 5mm
M8 Washer
Bright Screw
(43)–2
M10 x 95mm
Screw (76)–4
5
M4 x 16mm
Screw (90)–8
(91)–1