NordicTrack Gx 3.4 Bike User Manual page 9

7. While another person holds the Console (13)
near the Handlebar (5), connect the wires on the
Console to the Upper Wire (59), the Pulse Wire
(61), and the Receiver Wire (16).
Insert the excess wire into the Handlebar (5).
Tip: Avoid pinching the wires. Attach the
Console (13) to the Handlebar (5) with four M4 x
16mm Screws (90).
8. Orient the Upright (4) assembly and the Pivot
Cover (12) as shown.
Slide the Pivot Cover (12) upward to the
Handlebar (5). Tip: Bend and flex the Pivot
Cover slightly to slide it over the Handlebar.
Attach the Pivot Cover (12) to the Handlebar
(5) and the Console (13) with four M4 x 16mm
Screws (90).
Pivot the Handlebar (5) until the hole in the
Handlebar is aligned with an adjustment hole in
the Upright (4).
Tighten an Adjustment Knob (27) into the
Handlebar (5) and an adjustment hole in the
Upright (4). Make sure that the Adjustment
Knob is engaged in one of the adjustment
holes.
7
61
16
8
Hole
Adjustment
Holes
90
27
9
13
Avoid pinching
the wires
59
5
90
13
5
12
90
90
4