Upright (9) - NordicTrack Grt470 Manual

24. Identify the Weight Cable (72). It is approximately
118 1/4Ó long and it has a closed loop on one end
and a bolt on the other.
Thread the 1/2Ó Plain Nut (100) onto the bolt at the
end of the Weight Cable (72). Place the Long Weight
Spacer (96) over the Weight Tube (17) and place the
1/2Ó Flat Washer (98) on top of the Long Weight
Spacer. Thread the bolt at the end of the Weight
Cable into the Weight Tube.
Note: The bolt at the end of the Weight Cable is
one of the means for tightening the Cables (72,
73, 74, and 75). When you have mounted all
Cables, use the following procedure for tightening
the Cables: Thread the bolt into the Weight Tube
(17) until all Cables are tight and rest firmly in the
grooves of all Pulleys. Then tighten the 1/2Ó Plain
Nut (100) onto the 1/2Ó Washer (98).
25. Route the Weight Cable (72) through the opening
between the Weight Guides (15) as shown and then
through the slot in the Weight Upright (9).
Route the Weight Cable (72) over a 3 1/2Ó Pulley (24)
as shown. Attach the 3 1/2Ó Pulley inside the slot in
the Weight Upright (9) with a 3/8Ó x 2 3/4Ó Bolt (46),
two 3/8Ó Flat Washers (48), two 5/8Ó x 1/2Ó Spacers
(102) and a 3/8Ó Nylon Locknut (50).
24
100
17
25
50
48
Slot
72
15
13
72
98
96
9
102
24
48
102
46