NordicTrack Grt470 Manual page 9

11. Place two Weight Bumpers (51) over the indicated
holes in the bracket on the Weight Base (5). Insert
the Weight Guides (15) into the holes.
See the inset drawing. Insert two Weight Inserts (94)
into each Weight (21) as shown. Turn the Weights so
the large pin grooves point toward the floor.
Slide all of the included Weights (21) onto the Weight
Guides (15). Make sure that the Weights are
turned so the pin grooves are on the side shown.
Press a Weight Tube Bumper (18) into the lower end
of the Weight Tube (17). Slide the Top Weight assem-
bly (16) onto the Weight Guides (15).
Attach the Weight Guides (15) to the welded tube on
the Weight Base (5) with a 3/8Ó x 6 1/2Ó Bolt (55) and
a 3/8Ó Nylon Locknut (50).
12. Attach the Weight Guides (15) to the welded tube on
the Weight Upright (9) with a 3/8Ó x 6 1/2Ó Bolt (55)
and a 3/8Ó Nylon Locknut (50).
13. Press a 2Ó Square Inner Cap (28) into the top of the
Press Front Leg (20).
Slide the Press Front Leg (20) onto the indicated
5/16Ó x 2 1/2Ó Carriage Bolts (92) in the Press Base
(6). Hand tighten two 5/16Ó Nylon Locknuts (64) onto
the Bolts. Do not tighten the Nylon Locknuts yet.
11
15
16
17
18
Groove
Pin
Grooves
5
51
50
Welded
Tube
12
50
Welded
Tube
15
13
28
20
64
9
94
Large Pin
Groove
21
51
55
9
55
64
6
92
21