Table of Contents
Advertisement
Frame Assembly
1. Before beginning, make sure that you have read
and understood the information on page 4.
Locate and open the parts bags labeled ÒFRAME
ASSEMBLY METALÓ and ÒFRAME ASSEMBLY
PLASTIC.Ó
See drawing 1a. Press a 2Ó Square Inner Cap (28)
into each end of the Butterfly Base (4).
Insert four 5/16Ó x 2 1/2Ó Carriage Bolts (92) up
through the indicated holes in the Butterfly Base (4).
Note: If the Bolts fall out, secure them by putting
a small piece of tape over the head of each Bolt.
Place the Butterfly Base flat on the floor.
Insert two 5/16Ó x 2 1/2Ó Carriage Bolts (92) up
through the indicated holes in the Weight Base (5).
Place the Weight Base flat on the floor.
See drawing 1b. Attach the Weight Base (5) to the
Butterfly Base (4) with two 5/16Ó x 2 3/4Ó Bolts (89),
two 5/16Ó Washers (36), and two 5/16Ó Nylon
Locknuts (64).
2. See drawing 2a. Press a 2Ó Square Inner Cap (28)
into each end of the Press Base (6).
Insert four 5/16Ó x 2 1/2Ó Carriage Bolts (92) up
through the indicated holes in the Press Base (6).
See drawing 2b. Attach the Press Base (6) to the
Weight Base (5) with two 5/16Ó x 2 3/4Ó Bolts (89),
two 5/16Ó Washers (36), and two 5/16Ó Nylon
Locknuts (64).
1a
4
92
28
1b
36
89
36
4
2a
5
28
2b
5
28
5
92
92
64
64
5
6
92
92
5
64
6
36
28
64
36
89
Hide quick links:
Advertisement
Table of Contents
