26. Place the Weight Cable (72) in the groove of a
3 1/2Ó Pulley (24) and push the Pulley up into the
welded bracket on the Weight Upright (9). Attach the
3 1/2Ó Pulley inside the welded bracket on the Weight
Upright (9) with a 3/8Ó x 1 3/4Ó Bolt (57) and a
3/8Ó Nylon Locknut (50).
27. Remove both 3 1/2Ó Pulleys (24) from the pre-assem-
bled Pulley Frame (22).
Wrap the Weight Cable (72) around a 3 1/2Ó Pulley
(24) in the direction shown. Attach the 3 1/2Ó Pulley to
the Pulley Frame (22) with a 3/8Ó x 1 3/4Ó Bolt (57)
and a 3/8Ó Nylon Locknut (50). Make sure that the
Pulley Frame is turned as shown.
28. Attach the closed loop on the Weight Cable (72)
inside the indicated slot in the Weight Upright (9) with
a 3/8Ó x 2 3/4Ó Bolt (46), two 3/8Ó Flat Washers (48),
and a 3/8Ó Nylon Locknut (50).
26
50
24
72
27
50
28
50
48
9
14
9
Welded
Bracket
57
72
24
57
22
72
48
46
Slot