KTM 990 ADVENTURE EU Owner's Manual page 57

RIDING INSTRUCTIONS
–
When conditions allow (incline, road situation, etc.), you can shift into a higher gear.
–
Release the throttle while simultaneously pulling the clutch lever, shift into the next
gear, release the clutch and open the throttle.
Info
You can see the positions of the six forward gears in the figure. The neutral or
idle position is between the first and second gears. First gear is used for starting
off or for steep inclines.
The operating temperature is reached when 6 bars of the temperature indicator
light up.
100527-10
–
After reaching maximum speed by fully opening the throttle grip, turn the throttle back
so it is ¾ open. This will barely reduce the speed but fuel consumption will be consid-
erably lower.
–
Accelerate only up to a speed suitable for the road surface and weather conditions.
When traveling in bends, do not shift, and accelerate very carefully.
–
To shift down, brake if necessary and close the throttle at the same time.
–
Pull the clutch lever and shift into a lower gear, release the clutch lever slowly and open
the throttle or shift again.
–
If the engine is killed at an intersection, for example, just pull the clutch lever and
press the E starter button. The transmission does not need to be shifted into neutral.
–
Switch off the engine if you expect to be standing for a long time.
–
If the FI warning lamp (MIL) lights up during a trip, stop immediately. When you shift to
neutral, the FI warning lamp (MIL) starts to flash.
Info
From the flashing rhythm, you can derive a two-digit number, the so-called
flashing code. The flashing code tells you which component has a fault.
–
If the ice symbol
Adjust your speed to the road conditions.
appears in the combination instrument, the streets may be icy.
55