KTM 990 ADVENTURE EU Owner's Manual page 121

WHEELS, TIRES
–
Mount the rubber dampers and rear sprocket carrier in the rear wheel.
–
Place the rear wheel in the swingarm and bring the brake disc on the brake caliper into
contact.
–
Mount the wheel spindle but do not push it in all the way.
–
Push the rear wheel as far forward as possible and place the chain on the rear sprocket.
–
Push the wheel spindle in all the way and mount chain adjuster
Info
Mount chain adjuster
–
Push the rear wheel forward so that the chain adjusters are in contact with the adjust-
ing screws, and tighten nut
100636-10
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Nut, rear wheel spindle
(990 Adventure)
–
Insert wheel speed sensor
Guideline
Screw, wheel speed sen-
sor, rear
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc and
there is a pressure point.
100635-11
Subsequent work
–
Raise the vehicle off of the center stand. (
and in the same position.
2 3
.
4
M25x1.5 90 Nm
(66.4 lbf ft)
into the hole. Mount and tighten screw
5
M6 8 Nm
(5.9 lbf ft)
p. 77)
119
and nut .
3 4
.
B
Thread greased
.
6
Loctite ® 243™