Using The Ez-Lock 35Mm Slide Holder - Microtek ScanMaker i800 Plus Supplement Manual

A. Using the EZ-Lock 35mm Slide Holder
To scan 35mm slides, use the EZ-Lock 35mm
Slide Holder, which can hold up to 12
mounted 35mm slides at a time.
1. Place the 35mm slides to be scanned inside the individual frames of the EZ-Lock
2. Raise the scanner lid, then place the EZ-Lock 35mm Slide Holder towards the back
Keep calibration strip
on the glass surface clear
and free of any obstruction
"Microtek" logo
8 ScanMaker i800 Plus Supplement
35mm Slide Holder. The shiny base of the 35mm slide should be facing down, and
the emulsion side of the slide should be facing up.
Orient the holder with
the "Microtek" logo
facing up
of the scanner, with the loaded film on the scanner glass surface.
To make sure the auto multiframe
cropping feature performs correctly,
place the holder on the scan bed,
correctly oriented and showing the
side with the Microtek logo face up.
Align the red arrows so that the
holder's front edge is flush against
the top ruler of the scanner.