Calibration Setup - Microtek ScanMaker i800 Plus Supplement Manual

Calibration Setup

With the target properly positioned on the scanner, turn on your scanner and
let it warm up for about five minutes. Launch the MSP program; the MSP main
window appears.
A
B
A. Choose the scanner model that you are calibrating.
B. Choose the correct target media. If you are calibrating the reflective target, select
C. Select the date code and target type
D. When all the settings are done, click the Start (or Start Profiling) button. The
26 ScanMaker i800 Plus Supplement
Reflective. Otherwise, select Positive.
(or reference number) from the drop-
down list that matches your target.
You can verify this information by
looking at the left and right corners
of the target's bottom margin.
If the desired data file is not present in the drop-down menu, install the IT8
Calibration Data to update the target profiles in your system.
calibration window will appear, and an initial preview of the target is performed.
D
C
Date code and target type information