Scanning Film - Microtek ScanMaker i460 Start Here Manual

Scanning Film

1. Place the film.
To scan film, use the LightLid 35 IV. Refer to "Using the LightLid 35 IV" in this guide
to load film.
2. Launch ScanWizard EZ.
Follow the step 2 in "Scanning Photos" on previous page to launch ScanWizard EZ.
3. Switch to ScanWizard EZ - Professional Mode.
Click the Professional Mode button on the control panel of the EZ Mode to switch to
the Professional Mode.
4. In the Preview window of the Professional Mode, click the Scan Material button to
choose Negative Film for negatives; choose Positive Film for transparencies and slides,
depending on the film type you are using.
5. Click the Overview button to perform a preliminary scan of the film loaded onto the
scanner.
6. Select the Scan Frame tool, and choose the area to be scanned by sizing the marquee
around the targeted area.
7. Specify your scanning requirements in the Settings window. Choose the desired image
type and resolution, and adjust the scan frame settings if necessary.
8. Adjust image quality if necessary, using the Advanced Image Correction tools.
9. Click the Scan to button in the Preview window to scan the film.
Settings window
Preview window
6
Press to switch to
ScanWizard EZ - EZ Mode
Press to switch to
ScanWizard EZ - Advanced
Mode
Scan Job Queue
window
Click NEW to create
more scan frames