Scanning Film (1) - Microtek ScanMaker i450 Supplement Manual

D. Scanning Film (1)
This scenario uses the ScanWizard EZ - Advanced Mode.
1. Raise the scanner lid, then follow the
2. Follow the procedures (step 2 and 3) in
3. Click the Preferences button (
4. If necessary, specify other settings related to your output image in the Preferences
5. Click the Preview button (
6. After a preview image is shown in Preview area, if necessary, you can resize the
7. Click the Select button (
8. Specify the scanning requirements depending on your purpose about
16 ScanMaker i450 Supplement
procedures in the "Positioning Transparent
Film" section to load the film and to place the
film holder on the scanner glass surface. Gently
lower the scanner lid down onto the scanner
scan bed.
"Scanning Photos (2)" to activate the
ScanWizard EZ - Advanced Mode.
Film for transparencies and slides; choose Negative Film for negatives, depending
on the film type you are using.
window.
a) Select a desired scan quality from Speed, Quality, and Best Quality options in
the Scan Mode layer.
b) Specify the folder location, a file name, and the file format for the output
image in the Save layer.
c) Specify a preferred application to open your output image in the Save layer.
image, which will appear in the Preview area at the right side of the window.
scan frame (floating dotted line) around the image by dragging on the edge or
corner of the scan frame to determine the final size of the actual scan.
related option settings.
manipulating the image.
- Select a desired viewing size for the on-screen display purpose.
- Select a desired output dimension and a resolution for printing purpose.
- Set up a custom resolution.
) to open the Preferences window; then Positive
) to perform a preliminary view of the entire
) to activate a display of nine-image effects and