Adapt Microwave Oven Blower For Recirculation - GE JVM2052 Installation Instructions Manual

C3 ADAPT MICROWAVE OVEN
BLOWER FOR RECIRCULATION
Remove and save 3 blower plate screws
1
and 2 blower unit mounting screws.
Blower unit
Carefully pull out the blower unit. The wires
2
will extend far enough to allow you to adjust the
blower unit.
3
Roll the blower unit 90° so that fan blade openings
are facing toward the front of the microwave oven.
BEFORE: Fan Blade
Openings Facing Up
Roll
Installation Instructions
Blower plate
mounting screw
(3 screws)
Blower plate
Back plate
Blower unit
mounting screw
(2 screws)
20
AFTER: Fan Blade
Openings Facing
Forward
NOTE: Make sure wires remain routed in the grooves
of the motor frame.
4 Place the blower unit back into the opening.
WARNING:
cause injury or death. Do not pull or stretch the
blower unit wiring. Make sure the wires are not
pinched.
5 Reattach the blower plate to the microwave oven.
Attach with the 3 blower plate mounting screws
and then the 2 blower unit mounting screws.
Blower unit
Risk of electric shock can
Blower plate
mounting screw
(3 screws)
Blower plate
Back plate
Blower unit
mounting screw
(2 screws)