Adapting Microwave Blower For Recirculation; Mount The Microwave Oven - GE JVM6172SKSS Installation Instructions Manual

C4. ADAPTING MICROWAVE BLOWER
FOR RECIRCULATION (cont.)
6 Remove the metal vent fan cover on the back of the
microwave by sliding it up.
Close the blower door. Slide blower shield onto the
7
top of the blower door opening.
8 Secure the blower to the microwave using the blower
retaining screws from Step 1.
Installation Instructions
Blower Retaining
Screw
Blower
Retaining
Screws
Back of
Microwave
Oven
22
C5.

MOUNT THE MICROWAVE OVEN

CAUTION
FOR EASIER INSTALLATION AND
PERSONAL SAFETY, WE RECOMMEND THAT TWO
PEOPLE INSTALL THIS MICROWAVE OVEN.
IMPORTANT: Do not grip or use handle during
installation.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the
cord.
NOTE: We recommend using filler blocks if the
cabinet front hangs below the cabinet bottom shelf.
IMPORTANT: If filler blocks are not used,
case damage may occur from overtightening
screws.
NOTE: When mounting the
microwave oven, thread
power cord through hole
in bottom of top cabinet.
Keep it tight throughout
Steps 1–3. Do not pinch
cord or lift oven by pulling
cord.
2 Rotate front of oven up
against cabinet
bottom.
1
Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.