PLACEMENT OF THE MOUNTING PLATE
1
A
REMOVING THE MICROWAVE
OVEN FROM THE CARTON/
REMOVING THE MOUNTING
PLATE
1
Remove the installation instructions, filters, glass tray
and the small hardware bag. Do not remove the
Styrofoam protecting the front of the oven.
Fold back all 4 carton flaps fully against carton sides.
2
Then carefully roll the oven and carton over onto the top
side. The oven should be resting in the Styrofoam.
Styrofoam
3
Pull the carton up and off the oven.
4
Remove and properly discard plastic bags.
Screws
Remove the 2 screws from the mounting plate. This
5
plate will be used as the rear wall template and for
mounting. You may discard these screws.
Installation Instructions
Carton
Mounting
Plate
B
FINDING THE WALL STUDS
Wall
Studs
Center
1
Find the studs, using one of the following
methods:
A. Stud finder – a magnetic device which
locates nails.
B. Use a hammer to tap lightly across the
mounting surface to find a solid sound.
This will indicate a stud location.
2
After locating the stud(s), find the center by
probing the wall with a small nail to find the edges
of the stud. Then place a mark halfway between
the edges. The center of any adjacent studs should
be 16" or 24" from this mark.
3
Draw a line down the center of the studs.
IMPORTANT: The microwave oven must be connected
to at least one wall stud.
8
OR