Adapt Microwave Oven Blower; For Outside Back Exhaust - GE JVM2052 Installation Instructions Manual

B4 ADAPT MICROWAVE OVEN
BLOWER FOR OUTSIDE BACK
EXHAUST (cont.)
3 Carefully pull out the blower unit. The wires
will extend far enough to allow you to adjust
the blower unit.
BEFORE: Fan Blade
Openings Facing Up
End A
4
Rotate the unit so that the exhaust ports face
the rear of the cabinet. When you insert the blower
unit, the blower wire must be as shown.
5 Place the blower unit back into the cabinet.
Check that the exhaust ports face toward
the rear of the cabinet.
WARNING:
can cause injury or death. Do not pull or stretch
the blower unit wiring. Make sure the wires
are not pinched.
NOTE: The blower unit exhaust openings should
match exhaust openings on rear of microwave oven.
Installation Instructions
End B
Blower unit
Exhaust ports
Exhaust ports
Risk of electric shock
Reattach the blower plate to the cabinet so
6
the exhaust ports and blower plate opening
are aligned. Attach with 2 blower unit mounting
screws and then 3 blower plate mounting screws.
Blower unit
Blower unit exhaust ports
7 Attach the exhaust adapter to the rear of the
oven by sliding it into the guides at the top
center of the back of the oven.
Adapter
Guide
Push in securely until it is in the lower locking
tabs. Take care to ensure that the damper hinge
is installed so that it is at the top and that the
damper swings freely.
17
Blower plate
mounting screw
(3 screws)
Blower plate
Back plate
Blower unit
mounting screw
(2 screws)
Back of
Microwave Oven
Guide
Locking Tabs