Attach Mounting Plate To Wall; Preparation Of Top Cabinet; Adapt Microwave Oven Blower For Outside Back Exhaust - GE JVM2052 Installation Instructions Manual

ATTACH THE MOUNTING PLATE
B2
TO THE WALL
Attach the plate to the wall using toggle bolts.
At least one wood screw must be used to attach
the plate to a wall stud.
1 Remove the toggle wings from the bolts.
Insert the bolts into the mounting plate through
2
the holes designated to go into drywall and reattach
" onto each bolt.
the toggle wings to 3 ⁄
4
To use toggle bolts:
Spacing for Toggles More
Than Wall Thickness
Toggle Wings
Mounting
Toggle
Plate
Bolt
Wall
3 Place the mounting plate against the wall and insert
the toggle wings into the holes in the wall to mount
the plate.
NOTE: Before tightening toggle bolts and wood screw,
make sure the tabs on the mounting plate touch
the bottom of the cabinet when pushed flush against
the wall and that the plate is properly centered under
the cabinet.
CAUTION:
Be careful to avoid pinching
fingers between the back of the mounting plate and
the wall.
4
Tighten all bolts. Pull the plate away from the wall
to help tighten the bolts.
Installation Instructions
Bolt End
16
USE TOP CABINET TEMPLATE FOR
B3

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws and
a hole large enough for the power cord to fit through.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
Wear safety goggles when
drilling holes in the cabinet bottom.
B4 ADAPT MICROWAVE OVEN
BLOWER FOR OUTSIDE BACK
EXHAUST
1 Remove and save 3 blower plate mounting screws
and 2 blower unit mounting screws.
Blower unit
Use side cutters or tin snips to cut and remove
knockouts from back plate. Discard the knockouts.
Be careful not to distort the plate.
Knockouts
Blower plate
mounting screw
(3 screws)
Blower plate
Back plate
Blower unit
mounting screw
(2 screws)