Preparation Of Top Cabinet; Attach Exhaust Damper; Mount The Microwave Oven - GE JVM2052 Installation Instructions Manual

A2 USE TOP CABINET TEMPLATE FOR

PREPARATION OF TOP CABINET

You need to drill holes for the top support screws, a hole
large enough for the power cord to fit through, and
a cutout large enough for the exhaust adaptor.
• Read the instructions on the TOP CABINET TEMPLATE.
• Tape it underneath the top cabinet.
• Drill the holes, following the instructions on the TOP
CABINET TEMPLATE.
CAUTION:
Wear safety goggles when
drilling holes in the cabinet bottom.
A3

ATTACH EXHAUST DAMPER

Blower unit
• Place the microwave oven in its upright position, with
the top of the unit facing up.
• This microwave oven is shipped assembled for top
exhaust.
• Attach the exhaust adapter to the blower plate by
sliding it into the guide.
• You will need to make adjustments to ensure proper
alignment with your house exhaust duct after the
microwave oven is installed.
Installation Instructions
Blower plate
mounting screw
(3 screws)
Blower plate
Back plate
Blower unit
mounting screw
(2 screws)
13
A4

MOUNT THE MICROWAVE OVEN

CAUTION:
To avoid the risk of personal
injury (back injury or other injuries due to excessive
weight of the microwave oven) or property damage,
you will need two people to install this microwave
oven.
IMPORTANT: Do not grip or use handle during
installation.
WARNING:
cause injury or death: If installing unit with metal
countertops, cover the edge of the power supply
cord hole with the power supply cord bushing.
IMPORTANT: If filler blocks are not used, case damage
may occur from overtightening screws.
NOTE: When mounting
the microwave oven,
thread power cord through
hole in bottom of top
cabinet. Keep it tight
throughout Steps 1–3. Do
not pinch cord or lift oven
by pulling cord.
2 Rotate front of oven up
against cabinet bottom.
3 Insert a self-aligning screw through top-center
cabinet hole. Temporarily secure the oven by
turning the screw at least two full turns after
the threads have engaged. (It will be completely
tightened later.)
Risk of Electric Shock. Can
1 Lift microwave oven,
tilt it forward, and hook
slots at back bottom
edge onto four lower
tabs of mounting plate.