Table of Contents
Advertisement
8.6 Removing/Installing the Back Frame
Removing
1.
Fold the back down. Refer to Unfolding/Folding the Back on
page 43.
2.
Loosen rear seat upholstery screw and short mounting screw but
DO NOT remove.
3.
Remove the two long mounting screws, plastic washers, coved
spacers, washers, and lock nuts that secures the back angle plates
to the seat rails/base frame.
4.
Remove the back assembly from the wheelchair.
Installing
1.
Place back assembly on wheelchair frame in folded position. Refer
to FIGURE 1 on page 44.
2.
Install the long mounting screw through plastic washer, back angle
plate, coved spacer and seat rail/base frame.
3.
Install washer and locknut onto long mounting screw.
4.
Perform STEPS 1- 3 for remaining back angle plate.
5.
Tighten long mounting screw enough to secure the back to the seat
rail, while allowing the back to fold properly.
6.
Securely tighten the locknut on the long mounting screw while
holding the long mounting screw from rotating.
7.
Securely tighten the short mounting screw and rear seat upholstery
mounting screw.
8.
Repeat STEPS 17 - 18 for remaining back angle plate.
9.
Unfold back to upright position. Refer to Unfolding/Folding the
Back on page 43.
Part No 1171880
Back Frame
Back Angle
Plate
Short Mounting
Coved Spacer
Seat Rail/Base Frame
Back shown in upright position and seat upholstery
not shown for clarity of hardware location.
FIGURE 11
59
Rear Seat Upholstery
Mounting Screw (Not
Shown)
Screw
Locknut
Washer
Removing/Installing the Back Frame
®
Invacare
Top End Reveal
8 BACK
Long
Mounting
Screw
Plastic
Washer
™
Wheelchair
Advertisement
Table of Contents
