Handrim Replacement - Invacare Top End Reveal User Manual

11 WHEELS

11.5 Handrim Replacement

1. Remove the rear wheel from the wheelchair. Refer to Removing/Installing Rear Wheels on page 66.
WARNING
Tire MUST be fully deflated before any disassembly procedures are performed. Otherwise injury or damage may result.
2. Remove all air from the tube by pressing down on the pin in the center of the valve stem.
3. While carefully holding the tire, tube and rim strip to one side, hold the allen screws and remove the locknuts that secure the handrim to the
rear wheel.
4. Remove the existing handrim.
5. Install new handrim by reversing STEPS 2-4.
WARNING
DO NOT inflate tire until it is completely
assembled. Otherwise injury or damage may
result.
6. Inflate tire to correct psi rating on the sidewall of tire.
7. Reinstall rear wheel to the wheelchair. Refer to Removing/Installing
Rear Wheels on page 66.
8. Repeat STEPS 1-7 for opposite rear wheel if necessary.
®
Invacare Top End Reveal
™
Wheelchair
Handrim
Locknut
FIGURE 5
70
Allen Screw
Handrim Replacement
Part No 1171880