Section 4-Front Riggings; Installing/Removing Front Riggings Assembly - Invacare Insignia Owner's Operator And Maintenance Manual

SECTION 4—FRONT RIGGINGS
SECTION 4—FRONT RIGGINGS
After any adjustments, repair or service and before use, make sure all attaching hardware is
tightened securely. Otherwise injury or damage may occur.

Installing/Removing Front Riggings Assembly

NOTE: For this procedure, refer to FIGURE 4.1.
Installing
1. Turn the front rigging assembly to the side (open front rigging is perpendicular to wheelchair).
2. Install the hinge plates on the front rigging assembly onto the hinge pins on the wheelchair frame.
3. Push the front rigging assembly towards the inside of the wheelchair until it locks into place. An "audible" click will be
heard when locked in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
Removing
1. Push the front rigging release lever inward.
2. Rotate swingaway front rigging assembly outward.
3. Lift the swingaway front rigging assembly off the hinge pins.
DETAIL "A"
Front
Rigging
Release
Lever
™
Insignia
WARNING
Front Rigging
Assembly
Hinge Plates/
Hinge Pins
FIGURE 4.1 Installing/Removing Front Riggings Assembly
20
DETAIL "B"
Hinge Plates/
Hinge Pins
Rotate inward to use.
Rotate outward to remove
Part No. 1163197