Using The O2 Holder; Cleaning The O2 Holder - Invacare Insignia Owner's Operator And Maintenance Manual

SECTION 11—OPTIONS

Using the O2 Holder

Only use O2 cylinders that are at least 10.7 inches in height and 4
cylinders will not secure in place properly which may result in injury and/or damage to the cylinder.
NOTE: For this procedure, refer to FIGURE 11.3.
1. Place the O2 cylinder in the O2 holder as shown (Detail "A").
2. Secure the O2 cylinder in place by rotating the locking knob clockwise (Detail "B"). Hand tighten only.
DETAIL "A"

Cleaning the O2 Holder

The user and O2 cylinder MUST be removed from the wheelchair when cleaning the O2 holder.
Otherwise, injury or damage may occur if cleaning agents come in contact with the O2
regulator.
1. Remove the user and the O
2. The O2 holder cleans easily with any household glass type cleaner.
NOTE: After the cleaning solution has dried, it is safe for the user to re‐occupy the wheelchair.
™
Insignia
WARNING
O2 Holder
O2 Cylinder
Locking Knob
O2 Cylinder
NOTE: O2 holder shown is not installed on the wheelchair for clarity.
FIGURE 11.3 Using the O2 Holder
WARNING
cylinder from the wheelchair.
2
3 / inches in diameter. Smaller O2
8
DETAIL "B"
44
O2
Holder
Part No. 1163197