HP NetServer AA 4000 Manual page 317

Chapter 14
IOPn.MtcScsiP status: Cannot obtain geometry data for DISKn, and it will be marked offline.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Error
Description The SCSI Provider was unable to get required size characteristics from the disk controller. The
disk will not be usable until the problem is corrected.
Action Make sure the disk drive is present and turned on. If the disk is part of a RAID configuration,
use your RAID configuration tool and verify the configuration parameters.
IOPn.MtcScsiP status: Cannot obtain SCSI cache mode page for DISKn. This is typical for RAID controllers.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Informational
Description The SCSI Provider requests SCSI cache mode page data from disk controllers. SCSI cache
mode page data contains disk characteristics and configuration information. Many RAID
adapters do not provide this information for the disks included in their configurations. This
information is not required for correct operation.
Action No action is required.
IOPn.MtcScsiP status: Cannot obtain SCSI mode page data for DISKn. This is typical for RAID controllers.
Variables n – the disk number; for example, DISK0, DISK1, DISK2
Severity Informational
Description The SCSI Provider requests SCSI mode page data from disk controllers. SCSI mode page data
contains disk characteristics and configuration information. Many RAID adapters do not
provide this information for the disks included in their configurations. This information is not
required for correct operation.
Action No action is required.
MtcScsiP and MtcScsiR Messages
307