Connecting The Isr 9288 Router Blades; Connecting To Ipr Gbe Ports; Routing Model For A Fully Configured Isr9288 - HP Cluster Platform Interconnects v2010 User Manual

Figure 7-2 Routing Model for a Fully Configured ISR9288
2
Use the following procedure to route and connect cables:
1. During factory integration, all cables are labelled with their origin and destination ports.
2. Begin at the bottom with the lowest line board in the chassis, as shown in
3. Working upwards through the line boards, dress the cables in the bracket hook that is
adjacent to the line board for each line card as follows:
a. Route the cables from ports 1 through 6 and ports 13 through 18 to the bracket hooks
on the left side, as shown by callout 2 in
b. For each line card, route the cables from Ports 7 through 12 and ports 19 through 24 to
the bracket hooks on the right side, as shown by callout 3 in
4. All cables are routed through the comb brackets and down the sides of the cabinet.
Note:
In systems with greater than 128 nodes, the new 800mm wide cabinet is used and it is not
necessary to route the cables up through the cable clamps
are routed through the comb brackets, and down the sides of the cabinet.

7.2 Connecting the ISR 9288 Router Blades

This section provides instructions on cable connections to the IPR and FCR router modules that
are installed in the ISR 9288 sRBD.

7.2.1 Connecting to IPR GbE Ports

Use the following procedure to connect a cable to the Gigabit Ethernet port:
1. Connect the small form-factor SFP GBIC connector to the GbE port on the IPR module.
2. Connect the other end of the cable to the appropriate device.
1
Figure
4
3
7-2.
Figure 7-2.
Section 4.4.3 (page
7.2 Connecting the ISR 9288 Router Blades
Figure 7-2.
63). All cables
89