Installing The Cache Module - HP DL360 User Manual

The Battery-Backed Write Cache Enabler, also called the battery pack, works with the cache module to
provide transportable data protection, increase overall controller performance, and maintain any cached
data for up to 72 hours. The NiMH batteries in the battery pack are continuously recharged through a
trickle-charging process whenever the system power is on. Under normal operating conditions, the battery
pack lasts for 3 years before replacement is necessary.
CAUTION:
remove the battery pack while an array capacity expansion, RAID level migration, or stripe
size migration is in progress.
CAUTION:
before unplugging the cable from the cache module. If the amber LED blinks after 15 seconds,
do not remove the cable from the cache module. The cache module is backing up data, and
data is lost if the cable is detached.
IMPORTANT:
error message is displayed when the server is powered up, indicating that the battery pack is
temporarily disabled. No action is necessary on your part. The internal circuitry automatically
recharges the batteries and enables the battery pack. This process might take up to four hours.
During this time, the cache module functions properly, but without the performance advantage
of the battery pack.
NOTE:
power is restored to the system, an initialization process writes the preserved data to the hard
drives.

Installing the cache module

Power down the server (on page 20).
1.
Extend the server from the rack (on page 20).
2.
Remove the access panel (on page 22).
3.
Remove the PCI riser board assembly (on page 24).
4.
To prevent a server malfunction or damage to the equipment, do not add or
After the server is powered down, wait 15 seconds and then check the amber LED
The battery pack might have a low charge when installed. In this case, a POST
The data protection and the time limit also apply if a power outage occurs. When
Hardware options installation 57