Hp Trusted Platform Module Option - HP DL360 User Manual

Install the redundant power supply into the bay until it clicks.
4.
Connect the power cord to the power supply.
5.
Use the strain relief clip from the server hardware kit to secure the power cord.
6.
Route the power cord through the cable management solution.
7.
Connect the power cord to the power source.
8.
Be sure that the power supply LED is green
9.

HP Trusted Platform Module option

Use these instructions to install and enable a TPM on a supported server. This procedure includes three
sections:
Installing the Trusted Platform Module board (on page 67).
1.
Retaining the recovery key/password (on page 68).
2.
Enabling the Trusted Platform Module (on page 69).
3.
("Rear panel LEDs and buttons" on page 10).
Hardware options installation 66