Advertisement
Sony Installation
Connecting System 4xi to Sony
[System 4 model and software
version displayed here]
(See note.)
(See note.)
(See note.)
(See note.)
(Note: Information depends on
System 4 setup.)
Config
Projector
as
Sony
__________ Changes in some switch configurations are not detected until the power is
Extron • System 4 xi Switcher Series • User's Manual • P/N 68-408-02 Rev. A
If the System 4xi is already configured for a Sony projector, go to step 4. If it is
not set up correctly, it will be necessary to change switch settings on the
System 4xi 's Main Controller Board. Begin at Step 1 to verify the correct
configuration.
1. Use the Front Panel to display the Information Menu to verify that the System 4xi
is already set up for the Sony projector. Apply power to the System 4xi and do
the following:
a. Press
to display the M
b. Press
or
to step to Menu 8.
c. Press
to select this menu.
d. Press
or
to display the configuration. The example to the left is general,
yours will show the System 4xi model name, the software version and the
following information:
PRJ = SONY
PRJ BAUD = 9600
UNIT No. = 000
HST BAUD = 9600 (value depends upon setup Menu 3)
2. Go to the procedure on page 2-3 of the System 4 xi User's Manual to remove the
System 4xi cover. Then go to page 2-4 and refer to the configuration below to
set up the Main Controller board. Continue with Step 3 (below) when the
configuration is correct.
SW1: 1-2-3-4 SW2 SW3
off-on-off-on
0
SW3
SW2
SW4
3. Double-check your work and be sure the System 4xi cover is on securely.
4. Install the System 4xi in its place of operation (i.e. rack), but not powered on.
removed at the AC cord, and then restored.
Refer to the following connection diagram and continue.
Configuration and Connections
S
on the LCD screen.
ENU
ELECT
SW4 SW5 SW6 Prj Cable
0
3
5
0
Comm
Adapter
J15
26-312-01
SW5
J15
SW1
ON
Page 1
Advertisement
