Darkening Or Lightening A Copy; Copying A Photo; Using The Default Settings To Copy A Photo; Adjusting The Settings And Copying A Photo - Kodak HERO 2.2 Extended User Manual

Darkening or lightening a copy

1. Place the original document in the ADF or on the scanner glass (see
2. Press .
3. Press to select Copy Document, then press OK.
4. Press to select Brightness.
5. Press or to select a number below zero for a darker copy or select a number above zero for a lighter copy.
6. Press to begin copying.

Copying a photo

You can copy a photo using the default settings, or you can make adjustments to the quantity, size, quality and
brightness of your copies.

Using the default settings to copy a photo

The default settings are either the factory default settings (see
have set on the printer (see Save as Defaults at the bottom of the table under
photo, 45).
1. Lift the scanner lid, and place the original photo face down in the front right-hand corner of the scanner glass.
Do not load photos in the Automatic Document Feeder (ADF).
:
2. Close the scanner lid.
3. Press .
4. Press to select Copy Photo.
5. Press .

Adjusting the settings and copying a photo

1. Lift the scanner lid, and place the original photo face down in the front right-hand corner of the scanner glass.
Resetting factory defaults,
www.kodak.com/go/aiosupport
KODAK HERO 2.2 All-in-One Printer
Loading originals, 29).
78), or defaults that you
Adjusting the settings and copying a
45