Kodak HERO 2.2 Extended User Manual page 12

Networking Your Printer
4. Press to select your network name, then press OK.
If you can't see your network in the list, or if you want to change your network, select Rescan for Wireless
Networks, then press OK.
NOTE: If the name of your network is not listed, make sure your wireless router is turned on and within range.
5. If your network requires a password, use the LCD keyboard to enter your Security String. The Security String is
case-sensitive.
6. When the confirmation message appears, press OK.
When the printer is successfully connected, the Wi-Fi connectivity LED will stop blinking and remains lit.
The printer with a wireless connection is listed as the name of the printer plus a number (for example,
KodakHERO2.2+xxxx).
7. If you haven't yet installed the KODAK All-in-One Printer Software, insert the CD that came with the printer into
the computer CD drive and follow the on-screen instructions. When the software checks for updates, if a newer
version exists, install the newer version. (On a computer with MAC OS, make sure you select the option to check
for newer versions.)
NOTE: If you do not have the CD:
a. Go to www.kodak.com/go/aiodownloads.
b. In the results list, click the link for KODAK All-in-One Printer Software for your computer's operating system.
c. Follow the on-screen instructions.
Connecting to a WPS wireless router
If your router supports Wi-Fi Protected Set-Up (WPS), use WPS Connect. WPS lets you configure your printer for
a wireless network by pressing buttons or entering a PIN.
To connect to a network using WPS:
1. Press .
2. Press to select Network Settings, then press OK.
3. With Wi-Fi Set-Up Wizard selected, press OK.
: The Wi-Fi radio turns on automatically when you select Wi-Fi Set-Up Wizard.
4. With WPS Connect selected, press OK.
6
On the control panel, press
numbers. When you have finished, select DONE, then press OK.
www.kodak.com/go/aiosupport
, , or to select the letters and