Configuring Ip/Mac Address Binding - NETGEAR ProSafe FVS336Gv2 Reference Manual

ProSafe Dual WAN Gigabit Firewall with SSL & IPsec VPN FVS336Gv2 Reference Manual
2. Select the Source MAC Filter tab.
3. Click Yes to enable Source MAC Filtering.
4. Select the action to be taken on outbound traffic from the listed MAC addresses:
- Block this list and permit all other MAC addresses.
- Permit this list and block all other MAC addresses.
5. Enter a MAC Address in the Add Source MAC Address checkbox and click Add. The
MAC address will appear in the MAC Addresses table. Repeat this process to add
additional MAC addresses.
A valid MAC address is six colon-separated pairs of hexadecimal digits (0 to 9 and a to f).
For example: 01:23:45:ab:cd:ef.
6. Click Apply to save your settings.
You can edit the MAC address by clicking Edit in the Action column adjacent to the MAC
address.
To remove an entry from the table, select the MAC address entry and click Delete.
To select all the list of MAC addresses, click Select All. A checkmark will appear in the box to
the left of each MAC address in the MAC Addresses table

Configuring IP/MAC Address Binding

You can configure the VPN firewall to drop packets and generate an alert when a device
appears to have hijacked or spoofed another device's IP address. An IP address can be
bound to a specific MAC address either by using a DHCP reserved address (see
"Configuring DHCP Address Reservation"
Binding screen.
on page 37) or by manually binding on the IP/MAC
Chapter 4: Firewall Protection and Content Filtering
.
| 65